ソリューション ID: rd09231999_7598
掲載日: 2006年2月13日
製品カテゴリー: N/A
製品エリア: N/A
製品サブ・エリア: N/A

件名

Is there any way to monitor the ISP_DONE bit? (MAX^® 7000AE, MAX 7000B, MAX 3000A)

回答

The ISP_DONE bit is the last bit programmed during MAX 7000AE, MAX 7000B, or MAX 3000A in-system programming. It is used to protect these devices from damage should programming be interrupted prior to completion. This is done by preventing all I/O pins from driving until programming is completed. As such, this bit is not connected to an external pin.

To see if your MAX device was successfully programmed, you can add a pin to your design that drives out high. Connect this pin to a pull-down resistor on your board. If the pin drives high after programming is complete, then the device is functioning in user mode and has been successfully programmed. If it does not drive high, then the device was not successfully programmed.

If the programming is not successful, the programmer (MAX+PLUS® II, third party tester, or embedded Jam™ player) will give an error.

---

---

アルテラは、このソリューションがユーザーが意図した目的において機能することを保証するものではなく、ソリューションの使用に関する保証および信頼性に対しても責任を負わないものとします。